Operating System - OpenVMS
cancel
Showing results for 
Search instead for 
Did you mean: 

GS160 partition issue

 
bennyb
Occasional Advisor

GS160 partition issue

We have a GS160 that when powered on has problems with the HP_COUNT settings. Normally when I set a GS160 to HP_COUNT 0 and all of the QBB masks to 0. I should get this

system = QBB 0 1 + HS
QBB 0 = CPU 0 + Mem 0 + Dir + IOP + PCA 0 1 + GP (Hard QBB 0)
QBB 1 = CPU 0 + Mem + Dir + IOP + PCA + GP (Hard QBB 1)

instead I am getting this output:

system = QBB 0 1 + HS
QBB 0 = CPU 0 + Mem 0 + Dir + IOP + PCA 0 1 + GP (Hard QBB 0)
QBB 1 = CPU 0 + Mem + Dir + IOP + PCA + GP (Hard QBB 5)

any ideas why I can not get qbb1 to show up as hard partition 1 when I have the HP_COUNT set to 0?

regards,

Bennyb
2 REPLIES 2
marsh_1
Honored Contributor

Re: GS160 partition issue

have you checked which ports on the hsm they are plugged in to, could be logical qbb0 in gp0 hard qbb0 and logical qbb1 in gp5 hard qbb5
bennyb
Occasional Advisor

Re: GS160 partition issue

We have, they are connected to the correct ports on the H-Switch.

Bennyb