Propogating ACL's To New Files

[Robert Atkinson]

I'd like to know how to propogate and ACL onto any new files created in a particular directory.

Consider this scenario.

Directory is owner by SYSTEM
ACL on directory grants user 'X' Read+Write
File A.B is created by SYSTEM with default protection of (G:R,W:R)
User 'X' needs Read+Write+Delete access to file A.B by default (i.e. without issuing a separate SET SECURITY command).

Thanks, Rob.

[Robert Gezelter]

Rob,

You want to create ACEs in the directory's Access Control List that specify DEFAULT access.

I have to keep this short now, but I will post again shortly.

- Bob Gezelter, http://www.rlgsc.com

[Robert Atkinson]

I tried that with something like :-

/ACL=(IDENT=USERX,DEFAULT_PROTECTION,ACCESS=READ+WRITE+DELETE)

...but got an error back. I guess the syntax is wrong somewhere.

Rob.

[Karl Rohwedder · Accepted solution]

Rob,

you setup an ACE on the parent directoryfile with option DEFAULt, e.g.

$ Set Acl /Object=File -
/Acl=(Ident=USER_X,Access=R+W+D,Option=Default)-
DIREC.DIR

so every file created in DIREC gets this ACE.

It is also possible to specify a default protection schema like:

$ Set Acl /Object=File -
/Acl=(DEFAULT_PROTECTION,-
SYSTEM:RWED,OWNER:RWED,GROUP:RE,WORLD:RE,-
OPTIONS=DEFAULT)

Pls. note that file which already exist in the directory, will not get the ACE, it should be entered manually.

regards Kalle

[Robert Atkinson]

Cheers Karl - just what I was looking for.

Rob.

[Robert Gezelter]

Rob,

Sorry for the delay. I was attending to something urgent.

The following test case illustrates what I believe was requested in the post:

$ CREATE/DIRECTORY [.TEMP]

using EDIT/ACL add an ACE to the ACL as follows:
(IDENTIFIER=[1,1],OPTION=DEFAULT,ACCESS=READ)

[I freely admit that this is a nonsense example, bit it does convey the point)

Now, do:

$ COPY NL: [.TEMP]X.X
$ DIRECTORY/ACL [.TEMP]X.X

And the ACL will be correctly defaulted on [.TEMP]X.X

Information on the ACLs and ACEs is, among other places, in Chapter 1 of the "System Utilities Reference Manual", available from the OpenVMS www site at http://www.hp.com/go/openvms

I hope that the above is helpful.

- Bob Gezelter, http://www.rlgsc.com

[John Travell]

These days should this not be:
$ set security/acl[=(ace[,...])] object-name

JT:

[Jan van den Ende]

From Kall:

>>>
Pls. note that file which already exist in the directory, will not get the ACE, it should be entered manually.
<<<

For completeness:
$ SET ACL/DEFAULT [.dirspec]*.*.*
is all that needs done "manually"

There also is SET SECURITY, but that also affects ownership & default protectection. Of course, that might well be what you wish.

hth

Proost.

Have one on me.

jpe