TCP/IP V5.1 ECO 5 blocks all incoming telnet connections by default?

[Adrian Graham_1]

This is from a freshly booted box with otherwise nothing running, It's acting like I've created an access list on WE0. I checked output from a $tcpip sho serv telnet/full both before and after patching and it's the same - limit 250, current 0, peak 0.

OPCOM always shows the same error - "INTERnet ACP Telnet reject request - IP Address access list"

[Wim Van den Wyngaert]

Do you mean you have the problem starting from the first telnet or that there are no users present now ?

I'm on 5.3 eco 2 and I'm unable to get anything in the "accept netw". It just doesn't react to my commands. As 1 allow for 0.0.0.0 is enough, I wpould trry to remove the 182. ucx set servi /accept=nonetw=192...

Wim

[Wim Van den Wyngaert]

You can remove the service and configure it again. That should get rid of the access list.

[Adrian Graham_1]

Funnily enough that's what I've just done and it's now running happily so I'll patch up to ECO 5 again and see what happens!