Operating System - Tru64 Unix
cancel
Showing results for 
Search instead for 
Did you mean: 

Install TZ89 in a 4100 with Tru64 4.0G

SOLVED
Go to solution
HDgio
Regular Advisor

Install TZ89 in a 4100 with Tru64 4.0G

Hi
I have two 4100 with 4.0G and TZ89.
in console mode with "show dev" i see:
mkc100 TZ89.
when boot with the command scu scan edt, i can't see a TZ.
Why? need a driver? How I can install it ?
Thanks to all
3 REPLIES
Vladimir Fabecic
Honored Contributor
Solution

Re: Install TZ89 in a 4100 with Tru64 4.0G

Hello
Does scu see anything on bus 2 address 1?
Did you connect TZ89 to newly installed controller or to existing one (hope you have no address conflict)?
Anyway, you can try to boot generic kernel:
>>> boot -file genvmunix
and see if something changed.
If you installed a new controller with tape device, you must boot with genvmunix and rebuild the kernel with doconfig.
Regards
In vino veritas, in VMS cluster
HDgio
Regular Advisor

Re: Install TZ89 in a 4100 with Tru64 4.0G

It's OK
Thanks
HDgio
Regular Advisor

Re: Install TZ89 in a 4100 with Tru64 4.0G

I have found a solution to this question