Simpler Navigation for Servers and Operating Systems
Completed: a much simpler Servers and Operating Systems section of the Community. We combined many of the older boards, so you won't have to click through so many levels to get at the information you need. Check the consolidated boards here as many sub-forums are now single boards.
Operating System - Tru64 Unix
cancel
Showing results for 
Search instead for 
Did you mean: 

UPS Software for Tru64 V5.1B

Laura Salter
Occasional Visitor

UPS Software for Tru64 V5.1B

I have a DS25 Alpha Server running Tru64 V5.1B with two R3000 xr UPSs and 2 power units. I have tried using Lansafe to instigate a controlled shutdonw, but it will only manage 1 UPS. Is there any other UPS management software for this version of Unix, which will handle 2 UPSs supporting 1 server.
2 REPLIES
Phillip Brown
Frequent Advisor

Re: UPS Software for Tru64 V5.1B

Hey Laura,

According to the R3000 questions and answers page:

http://h18004.www1.hp.com/products/servers/proliantstorage/power-protection/rackups/r3000xr/questionsanswers.html

"The HP R3000 XR UPS supports HP Power Management Software (CPM) version 1.8. In addition the HP R3000 XR UPS also supports the LanSafe III management software."

You might start by checking here:

http://h18004.www1.hp.com/products/servers/proliantstorage/power-protection/rpmp.html

But, when you get to the HP Power Manager page:

http://h18004.www1.hp.com/products/servers/proliantstorage/power-protection/software/power-manager/index.html

You get this:

Monitor, manage and control devices - Single UPS only

Are you running the latest supported version of LanSafe III?
Laura Salter
Occasional Visitor

Re: UPS Software for Tru64 V5.1B

Phillip
Thanks for your reply.

I have looked at the HP pages you suggested. As far as I can tell the HP Power Management software doesn't run on Tru64.

I have tried 2 versions of Lansafe - V1.7 and V1.6. V1.6 will shut the processor, half of the peripherals and 1 of the UPSs down, but leaves the rest powered on. Looking at the documentation it doens't appear that either version will support 2 UPSs. I can re-load version V.17 if you think that will help.