mt -fsf command

[Bruno Vilardo]

Mohamed,

this is what it brings when io execute the command mt -f /dev/nrmt0h status.

mt -f /dev/nrmt0h status

DEVIOGET ELEMENT CONTENTS
---------------- --------
category DEV_TAPE
bus DEV_SCSI
interface SCSI
device TZ88
adpt_num 0
nexus_num 0
bus_num 5
ctlr_num 5
slave_num 11
dev_name tz
unit_num 11
soft_count 0
hard_count 10
stat 0x1
DEV_BOM
category_stat 0x1000000
DEV_81630_BPI

DEVGETINFO ELEMENT CONTENTS
------------------ --------
media_status 0x10001
BOM POS_VALID
unit_status 0x181
Ready 2_FM_Close NO_Rewind Compacting Buffered
record_size 0
density (current) 81630 BPI
density (on write) 0 BPI
Filemark Cnt 0
Record Cnt 0
Class 1 - DLT (tk)

MTIOCGET ELEMENT CONTENTS
---------------- --------
mt_type MT_ISSCSI
mt_dsreg 0x1
DEV_BOM
mt_erreg 0x3 Nonrecoverable medium error.
mt_resid 1
mt_fileno 0
mt_blkno 0
DEV_EEI_STATUS
version 0x2
status 0x3400 Device hardware error (hard error)
flags 0x1000007
CAM_STATUS SCSI_STATUS SCSI_SENSE CAM_DATA
cam_status 0x4 CCB request completed with an err
scsi_status 0x2 SCSI_STAT_CHECK_CONDITION
scsi_sense_data (hex)
f0 0 3 0 0 0 1 15
0 0 0 0 80 0 0 0
0 0 86 2 c0 0 0 65
1c 0 46 eb f 0 0 0
0 0 0 0 0 0 0 0
0 0 0 0 0 0
ASC/ASQ = 80/0 ASC/ASQ code not listed

NOte- There is a Hardware error on this message status.....

Thanks a lot
Bruno

[Mohamed K Ahmed]

There is an " Nonrecoverable medium error." message

I think your tape has gone bad
Check the procedure I gave you with a new tape


Mohamed

[Bruno Vilardo]

Mohamed ,
You are right ,

I cleaned the driver with a DLT tape cleaner ,and then i changed the tape and it´s working fine now ...
The tape was bad ...

Thanks a lot my friend ..

I appreciate.

Bru

[Mohamed K Ahmed]

Any time.
Some points for my hard thinking up North would be appreciated too

Thanks
Mohamed

[sunshine_3]

hi,

if you confirm default tape driver is /dev/nrmt0h, you should do following

1. # mt rewind

2. # mt fsf 1