HPe ProLiant DL360 Gen10 low performance hard disk drive with ESXi 6.7

[franxx]

Good morning,
I have been having a hard drive read/write problem on my HPe ProLiant DL360 Gen10 server for two weeks now.
This server currently has the VMware ESXi 6.7 operating system installed on a microSD card and two hard drives on RAID1 with a hardware RAID E208i-a controller.

I am currently using HPE Customized Image ESXi 6.7.0 Update 3 version 670.U3.10.5.5 released on March 2020 and based on VMware ESXi 6.7.0 Update 3. 

The performance of my hard drives at present is as follows image:

https://ibb.co/YbcdcVH 

I notice on the virtual machines on the host that they are considerably slower to upload operating system images and to read and write...

Are there any drivers I should install that I have not considered installing?

Thanks!

[StorageMike]

If not already I'd recommend pushing out SPP 2020.03.02, this is the SPP paired with your custom build and should have all the correct firmware and drivers.

http://vibsdepot.hpe.com/mapping/SPP-HPE_Custom-Image-vibsdepot-mapping-Gen9-later.pdf

[franxx]

Good morning,
First of all, thanks for responding so quickly, I appreciate it.
I'm very new at managing this type of server, and I'd say that I've never installed it, that is, I only put in the operating system that I mentioned but I haven't added any additional software.
How do I proceed to install it?
Is it done by ssh as well as an update or driver installation?
Greetings.

[StorageMike]

Hi

The SPP can be downloaded here https://techlibrary.hpe.com/us/en/enterprise/servers/products/service_pack/spp/index.aspx?version=gen10.2020.03.2

It's a bootable ISO which you can boot your server from (over ilo if remote) to upgrade firmware.

Further documentation is available on from the same site