PCM
cancel
Showing results for 
Search instead for 
Did you mean: 

AP 420, Procurve manager 2.1.5 firmware upgrade

 
Christian Ryeng
Occasional Visitor

AP 420, Procurve manager 2.1.5 firmware upgrade

Hello, I recently upgraded two of our companys 420 accesspoints with the new 2.1.5 firmware via cli, and this worked fine.

Then, i decided to test it with the Procurve Manager, and that failed hard. This is what the eventlog says:
Event type:
Application Event
Trap type:
N/A
Received from:
Software Update
Date received:
Wed Oct 18 13:02:58 CEST 2006
Date acknowledged:
Event has not been acknowledged.
Severity:
Major
Event Description
10.xx.xx.xx Error

I knew from browsing the forums that i had to set the communication paramters in the device before, but now the accesspoints have done a factory reset and is running 2.0.43-temp2 firmware. The old firmware was 2.1.2 and it was running boot rom version 3.0.6.

What has happened? Did someone set up us the bomb? o_O
3 REPLIES 3
GregJ_1
Occasional Advisor

Re: AP 420, Procurve manager 2.1.5 firmware upgrade

Hello Christian,

Is this something that you were able to duplicate more than once, or was this a result from one test? If the latter, then I would suggest opening a new call with ProCurve Support to report this issue (if you have not done so already). I have seen, on very rare occasions, what you have mentioned, and it is usually brought on by a corrupted image, or an upgrade that was prematurely stopped or lost connectivity to the network. Would need more detail though.

Thanks ... greg
Christian Ryeng
Occasional Visitor

Re: AP 420, Procurve manager 2.1.5 firmware upgrade

i tried it two times with the same results.
Lei.Ma
Frequent Advisor

Re: AP 420, Procurve manager 2.1.5 firmware upgrade

hi, did you have upgraded your PCM+?
http://66.35.221.171/WNDNames/software/standard_license_information.asp?fileName=http://www.hp.com/rnd/software/Download3_u8.htm
you can check this link, and upgrade your procurve manager plus.