PCM Maps and Cisco 3750

[Ramon Beringer]

Hi,
we have Problems in generating a Map with PCM. There is the following configuration :

HP 4108GL <-> Cisco C3750-48TS <-> HP 4104GL

On the HP Switches with old Firmware, which is fully supporting CDP, all Links in PCM are displayed correctly. With the new Firmware without full support of CDP the Links on the Map are no longer existent. LLDP is enabled on the Cisco Switch, and commands like "sh lldp neighbors detail" on the cisco or "sh lldp in remote-device" shows all the stuff which I expected there.

Any ideas where the Problem could be?

Regards,
Ramon

P.S. This thread has been moved from  Switches, Hubs, Modems (Legacy ITRC forum) to PCM. -HP Forum Moderator

[Holger Hasenaug · Accepted solution]

Even so LLDP is supported on Cisco devices since IOS 12.2.(37), the SNMP support for the LLDP MIB has just been added in IOS 12.2(50).

PCM use the LLDP SMNP MIB to gather LLDP information.

[Ramon Beringer]

Hi Holger,
thank you for your Information. We are using IOS 12.2.(46) currently. I will update it asap and give it a try.

Thanks,
Ramon

[Ramon Beringer]

Hi Holger,
our update did some time, because of difficult downtimes. The Switches are now running with 12.2(50) Images and PCM 3 shows the links on the maps correctly. PCM 2.x still don't. We will upgrade to PCM 3 in near Future so this should be no big Problem.

Thank you for your help. (10 Points) ;o)

Regards,
Ramon