- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Aruba & ProVision-based
- >
- 5406r zl2 Will Not Route
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-19-2016 12:18 PM
07-19-2016 12:18 PM
I have tried everything I can think of with this switch. But no matter what I have tried, I cannot get it to route!
I have tried enabling rip on all interfaces, ospf, bgp, all at once, none at all on the vlans. Nothing!
I am currently running the absolute basic routable configuration on this switch, and I cannot get the Vlans to talk to each other.
ip routing
vlan 10 ip address 10.7.10.1/24
vlan 20 ip address 10.7.20.1/24
int f1 untagged vlan 10
int f2 untagged vlan 20
show ip route show that the routes exist, and the computers plugged into F1, F2 can ping their respective gateways, but cannot ping each other.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-19-2016 04:26 PM
07-19-2016 04:26 PM
Re: 5406r zl2 Will Not Route
That is probably your windows firewall stopping the ping.
Test using simpler devices.
Test pinging the .1 address for the VLAN the host you are pinging from is not in.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-19-2016 04:36 PM
07-19-2016 04:36 PM
SolutionAfter 6 days of head scratching, countless hours on the phone with support, an RMAd switch. The problem was found.
If:
ip route
Is not the very first line in the config, after the modules, the switch will not route. There is no indication of anything being "wrong", it just doesn't work and a lot of the L3 behaviours will work inconsistently... eg. connected routes will randomly appear and disappear.
What a nightmare. I hope somebody else finds this helpful!