- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Aruba & ProVision-based
- >
- Better to use auto-edge-port or admin-edge-port, o...
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-15-2016 10:06 AM
02-15-2016 10:06 AM
Better to use auto-edge-port or admin-edge-port, on 5412zl switchports?
Switch Made/Model: USB HP 5412-92G-PoE+-2XG v2 zl Switch
Firmware: K.16.01.0004
Is it better practice to configure my individual switchports as admin-edge-port, or as auto-edge-port?
What acbout setting auto-edge-port on interfaces that are members of an LACP or trunk group?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-16-2016 03:44 AM
02-16-2016 03:44 AM
Re: Better to use auto-edge-port or admin-edge-port, on 5412zl switchports?
For ports that will be connected to user equipment, I always use admin-edge-port (and BPDU filter/protection).
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-18-2016 09:08 PM
02-18-2016 09:08 PM
Re: Better to use auto-edge-port or admin-edge-port, on 5412zl switchports?
Hello. Auto-edge will wait 3 seconds for the reception of a BPDU. If it does not receive one the port is declared an edge-port and does not participate in spanning-tree or transmit BPDUs out the port. If it does receive a BPDU then it is declared a non-edge-port and does participate.
Setting to admin-edge will cause the ports to immediately go to forward when the port comes onine. If they are connected to end hosts you basically end up saving the 3 second wait time.