ProCurve / ProVision-Based
cancel
Showing results for 
Search instead for 
Did you mean: 

HP Procurve 6600-24G-4XG ***Slow speed***

gojkog21
Advisor

HP Procurve 6600-24G-4XG ***Slow speed***

Hi,

I have a problem with my HP Procurve 6600. I've created four instances and connected them to each other. They can communicate (ping works), but when I try to test a speed, it is to slow (under 100Kb/s). Speed is the same when hosts are in the same instance and in different instances.

I've used pox and onos controllers, but there is no difference.

I've checked flows, and I think it's ok. (But it uses only software flow table.) I'll attach you flow table in the case where hosts are in the same instance (vlan10).

And I'll attach you packet-out message.

P.S Hosts have addresses 192.168.1.1 and 192.168.1.3. First, with address .1 is on port 3 on HP, and second with address .3 is on port 1 on HP.

Do you have any ideas, please?

 

1 REPLY
Richard Litchfield
Respected Contributor

Re: HP Procurve 6600-24G-4XG ***Slow speed***

 If you are talking OpenFlow, you probably want to post these queries in the SDN category within these communities.