- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Aruba & ProVision-based
- >
- HP Procurve Multiple VLAN on one port
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-04-2016 02:57 AM
11-04-2016 02:57 AM
HP Procurve Multiple VLAN on one port
Help???
I have 2 VM in Microsoft 2012 Hyper-V server using 2 different VLAN. VM1 is using VLAN 20 and VM2 is using VLAN9; And I'm using virtual switch to enable 2VMs to use a single LAN port. My question is How can I configure in HP procurve to allow a single port to use multiple VLAN.
Additional scenario: VM20 is using 192.168.20.10 gateway and VM9 is using 192.168.9.10 gateway which I configured in Watchguard.
The issue is if I untagged port as VLAN20 I can ping the 192.168.20.10 gateway but I cannot ping the other gateway. In the same way if I reverse to VLAN9.
Kindly help....
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-08-2016 04:19 PM
11-08-2016 04:19 PM
Re: HP Procurve Multiple VLAN on one port
You probably need to clarify where your ping test was from, as well as what your physical topology is meant to look like.
Assuming you have two VLANs on your network, and both VLANs are required to be extended to your Hyper-V environment, then both VLANs need to be:
1/ Created on the switch
2/ added as "tagged" to the switchport where you are patching from to the Hyper-V server.
If that doesn't work, check your vSwitch configuration.
Don't use untagged VLANs between the switch and the Hyper-V server.