Aruba & ProVision-based
1748021 Members
4745 Online
108757 Solutions
New Discussion

How to manual config default gateway in HP 1620-24G(JG913A)?

 
mak_soft
Occasional Contributor

How to manual config default gateway in HP 1620-24G(JG913A)?

I can't see this in  web-based console.

10 REPLIES 10
johnk3r
Respected Contributor

Re: How to manual config default gateway in HP 1620-24G(JG913A)?

Hi !!!

 

 

You have access to CLI?

**************************************
ATP FLEXNETWORK V3 | ACSA
mak_soft
Occasional Contributor

Re: How to manual config default gateway in HP 1620-24G(JG913A)?

This switch don't support telnet access,  com-console only.

But console access is not remote access. This switch is set high on the ceiling.

I can ping and web access to this switch from same subnet only.

 

What command do I run in com-console to manual config default gateway?

johnk3r
Respected Contributor

Re: How to manual config default gateway in HP 1620-24G(JG913A)?

What options you have in accessing the COM port?

 

I not found documentation for that switch and never configured this model ...

**************************************
ATP FLEXNETWORK V3 | ACSA
mak_soft
Occasional Contributor

Re: How to manual config default gateway in HP 1620-24G(JG913A)?

I have not tried to connect com-console...

 

I found documentation, but and can not remember where it was found.

My local copy hp1620-24g-emr_na-c04511057-3.pdf

malonion
Visitor

Re: How to manual config default gateway in HP 1620-24G(JG913A)?

Putty into Console - use speed 38400

Login

enter command without parenthesis:

ipsetup ip-address (enter IP) (enter subnet) default-gateway (enter gateway)

if you need to backspace use ctrl+backspace

Log into web GUI and save the new config.

Digit231
Occasional Visitor

Re: How to manual config default gateway in HP 1620-24G(JG913A)?

ipsetup ip-address (enter IP) (enter subnet) default-gateway (enter gateway)

I did try that, and work until I reboot the switch.  It flash like a christmas tree, took 5 minutes to reboot and reset it config to factory default.

Is this possible for some moderator to escalate this to engineering.  Why interface config in web interface does not allow to configure a gateway.  IP / Mask / Gateway are basic TCP/IP setting...

16again
Respected Contributor

Re: How to manual config default gateway in HP 1620-24G(JG913A)?

Are you running latest code? afail , this issue is already on HP's radar.

If gateway setting isn't still present, try using dhcp as work around.  (fix switch IP using dhcp reservation ) The DHCP supplied gateway works.

Digit231
Occasional Visitor

Re: How to manual config default gateway in HP 1620-24G(JG913A)?

I'm running 5.20.r1108 wich is 2 release late but I have check the Release note and there is nothing new related to gateway interface.

My issue is that I have two subnet, one for desktop and one for management.  My switch is on management subnet where dhcp give lease on the desktop subnet.

I know you try to help and offer workaround, but sometime feature are there for a reason and thing just need to do what they should do.  I'm not trying to send someone to Mars here !!!  Network device 101: IP / MASK /GATEWAY Geez !!!

Convergo
Frequent Advisor

Re: How to manual config default gateway in HP 1620-24G(JG913A)?

Hi,

updated to latest firmware today, but still not able to configure default gateway. Anyone ?