HPE Community
Web and Unmanaged
1752511 Members
5130 Online
108788 Solutions
New Discussion

Re: LACP in Procurve 1800 family switch

 
Lawagetas
New Member

‎05-21-2018 11:24 PM

‎05-21-2018 11:24 PM

LACP in Procurve 1800 family switch

Hello,

I'm wondering if the LACP protocol in Procurve 1800's family switches is based only on MAC address or uses also IP informations. I need to configure link aggregation of two Qnap NAS and I'm not sure the level of LACP in use on the switch. I think it'd be , probably, just MAC based being a level2 switch, but I could be wrong either.

Has someone the answer to this point?

Thanks a lot.

0 Kudos
1 REPLY 1
johnk3r
Respected Contributor

‎05-22-2018 11:03 AM

‎05-22-2018 11:03 AM

Re: LACP in Procurve 1800 family switch

Hi !

http://solitudo.net/hardware/manuals/1800-MgmtCfg-July2009-59916275.pdf

Page 27

 

 

**************************************
ATP FLEXNETWORK V3 | ACSA
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.