ProCurve / ProVision-Based
cancel
Showing results for 
Search instead for 
Did you mean: 

Problem Ip Route HP 6200 yl

JbOne73
Occasional Contributor

Problem Ip Route HP 6200 yl

Hi,

I try to set up a switch hp 6200yl with the command ip route but it not work.

I wrote this :

ProCurve(config)# ip route 207.95.7.0/24 207.95.6.157

And when i do :

ProCurve(config)# show ip route static

I don't see in the result my ip route and i don't understand ...

Can you help me please ?

Thank you so much

1 REPLY
parnassus
Honored Contributor

Re: Problem Ip Route HP 6200 yl

Those IP Addresses match with those used on some old HP documentation...it really doesn't matter...even if a real case (with sanitized outputs) would be of help.

Remember that IP static routes remain in the IP route table only so long as the IP interface to the next-hop router is up: if the next-hop interface goes down (or it is down), the switch software removes the static route from the Switch IP route table, if the next-hop interface comes up again, the software adds the route back to the route table (Reference here).

Is your next-hop interface (207.95.6.157) up?