- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Aruba & ProVision-based
- >
- Transitioning VLAN and DHCP to Procurve 2920
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-16-2015 08:31 AM
12-16-2015 08:31 AM
Transitioning VLAN and DHCP to Procurve 2920
Hello,
Let me begin by saying I am really a novice at this. I took over at a job where the network was already good to go I just needed to handle the day to day and future projects. I didnt realize the way the network was set up would prevent some projects.
Internet<-->Firewall<-->Filter<-->Switch
The problem is that the firewall is handling VLAN and DHCP and the filter needs to be upstream of at least the VLAN trunk(otherwise it sees all traffic as Peer-2-Peer). So I need to move the VLAN trunk and maybe DHCP to the switch. It is an HP ProCurve 2920-48G. It says that it can operate Layer 3 and that beyond the 15.6 firmware update it an handle DHCP. The switch is still on the 15.11 release and when I try and upload the new version it says that there is a download already in progress.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-08-2016 08:49 AM
01-08-2016 08:49 AM
Re: Transitioning VLAN and DHCP to Procurve 2920
In regards to the firmware update , have you tried applying the update via the USB port on the switch? You'll need to copy the latest firmware image to a flash drive and then run the following commands:
dir
copy usb flash [imagename_verison.swi] primary
boot system flash primary
If that doesn't work, you can also do it via TFTP via the console port as well.