- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Aruba & ProVision-based
- >
- Re: Two vlans on same port
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-25-2012 02:05 AM
12-25-2012 02:05 AM
Hi everyone,
I have HP Procurve Switch E6600ml-24XG(J9265A).
I have two vlans 100 and 101 configured. An HPUX server is connected via port 1. This server has two virtual IP addresses, one for each vlan:
- 192.168.100.10 -> vlan 100
- 192.168.101.10 - > vlan 101
I need this server to accept packets from the two vlans so I tagged his port (1) in the two vlans but it failed.
it only works by untagging the port in a single vlan each time but not both, and this is the problem.
I resolved similar issue in brocade switch using IP Subnet-based Vlan, but I don't find this option in this switch.
Any idea how to make this work ?
Thank you!
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-25-2012 02:41 PM
12-25-2012 02:41 PM
SolutionHi mr_red,
It sounds like your server is set up using interface aliases instead of VLANs. i.e. The addresses are both set up on the untagged VLAN.
The preferred way to fix this would be to change the server config so that at least one address is on a tagged VLAN interface. You could have one VLAN untagged and one tagged, or both tagged - it makes no difference which from the switch's perspective.
See http://www.hp.com/products1/serverconnectivity/adapters/ethernet/infolibrary/VLAN_wp.pdf for information on how to do this on HP-UX.
Paul
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-25-2012 10:57 PM
12-25-2012 10:57 PM
Re: Two vlans on same port
Thank you paulgear!
I have already tagged the interfaces on both sides and it resolved the problem.