Unable to set link speed

[PipingRockIT]

We've been using HP 2530 switches in front of our HA sonicwalls in order to split the incoming ISP service. Some of our ISPs hardware don't auto-neg properly and we have to statically set the port speed on the switch on the port the ISP comes in on. I had no issue doing this at another site, but for some reason the switches in use at the site I am currently setting up I am unable to set the port speed.  I get the following message when I try to set the port at 100-full..."Value 100-full is not applicable to port 10." I'm at a loss as to why it is preventing me from doing this when identical model switches had no issue at another location.

[Vince-Whirlwind]

Is there a firmware version difference between the switches?

does it accept auto-100? or 100Fdx? auto-1000? 1000Fdx? or any 10Mbps combination?

What are the ISP devices you are connecting to? Did you ask them to configure their interfaces properly so that auto-negotiation works?