- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Aruba & ProVision-based
- >
- fault finder lines in config
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО09-26-2017 10:12 AM
тАО09-26-2017 10:12 AM
fault finder lines in config
I have several 2900-48g switches, some of which display fault-finder lines in the config, and some of which don't.
The firmware is identical for all of them.
The lines in the switches where "fault-finder" appears are all prefixed with "no".
I don't want fault-finder enabled.
How do I stop the fault-finder lines from showing in the config ?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО09-26-2017 03:48 PM
тАО09-26-2017 03:48 PM
Re: fault finder lines in config
Joshua Kaplan_1 wrote: The lines in the switches where "fault-finder" appears are all prefixed with "no". I don't want fault-finder enabled.
Exactly, no fault-finder means probably "don't log Fault-Finder related messages"...if you don't want fault-finder to be enabled then no fault-finder is the way to go.
How do I stop the fault-finder lines from showing in the config ?
That's in contrast with the request above...if you don't want it enabled then the no fault-finder directive is necessary (AFAIK)...so you can't then trash that directive from configuration and pretend to have that feature disabled (since it seems enabled by default). Isn't it?
I'm not an HPE Employee
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО09-27-2017 11:08 AM
тАО09-27-2017 11:08 AM
Re: fault finder lines in config
" no fault-finder" results in "incomplete input: fault-finder"
I'm afraid that won't do it.
adding a question mark only shows the subparameters available, none of which disable the feature.