- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Aruba & ProVision-based
- >
- Re: hp solution Help
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-03-2016 03:26 PM
07-03-2016 03:26 PM
hp solution Help
I have HP 2920 core switch and HP 2530 Distribution Sw and HP 1920 Access Sw I Created 10 Vlans and configure windows server 2012 DHCP and Different scopes and configure Valn on HP 2920 and configure ip helper address and configure Port 24 Trunk on 2920 and port 24 Trunk on 2530 to use all Vlans Question is: what is the best solution to configure access SW 1920 to connect to 2530 to use all vlans to users.
Note: a lot of Switches 1920 will be connect to 2530
i want the best solution and config to do on all switches with no problem
Thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-04-2016 01:57 AM
07-04-2016 01:57 AM
Re: hp solution Help
If your Network Topology places the HP ProCurve 2530 as the real center Switch to which the most of HP OfficeConnect 1920 Switches are connected to you're forced to connect them via single or aggregated uplinks (trunks) to it. Then you just need to permit the necessary VLAN(s) to pass these trunks and you're basically done. Simply.
Other HPE OfficeConnect 1920 Switches can still connect to the HPE 2920 in the same way but, important, do not create loops (avoid loops).
Draw your desired Network Topology and you're done (from what you described your Network looks like a star with two centers - the 2920 and the 2530 inter-linked - where some 1920 Switches are going to be connected to the 2530, few others to the 2920).
I'm not an HPE Employee