support of SFP+ in 2930M

[areyeros]

Hi,

I need to confirm If i can use the connector with part-number 455883-B21 in a switch (2930M).

This is an SFP+ of HP and I want to confirm if we can also use it in an switch 2930M.

Thanks,

Regards, Alex

[Dennis_HP-ATP]

Hi Alex,

Did you try the following commands?

SHOW INTERFACES TRANSCEIVER DETAIL

or perhaps you can use the command:

(config) allow-unsupported-transceiver (available on ArubaOS from 16.02)

Rgds,

Dennis

[parnassus]

---

areyeros wrote: Hi, I need to confirm If i can use the connector with part-number 455883-B21 in a switch (2930M).
This is an SFP+ of HP and I want to confirm if we can also use it in an switch 2930M.
Thanks, Regards, Alex

---

Hello Alex,

since the 455883-B21 is a SFP+ Transceiver (and exactly for HPE BladeSystem c-Class) you shall need an Aruba 3810M/2930M 4SFP+ MACsec Module (JL083A) just in order to test it...an SFP+ Transceiver will not work (nor it will be recognized) when inserted into a SFP slot (Aruba 2930M frontplane slots are for SFP Transceivers).

An Aruba 2930M supported Short Range (SR) SFP+ Transceiver (using the JL083A) is the HPE X132 10G SFP+ LC SR Transceiver (J9150A).