HPE Community
ProLiant Deployment and Provisioning
1753971 Members
8077 Online
108811 Solutions
New Discussion

Re: Cannot get ML150G2 to boot to network with WinPE

 
Michael W Jones
Occasional Contributor

‎04-03-2006 06:20 AM

‎04-03-2006 06:20 AM

Cannot get ML150G2 to boot to network with WinPE

Has anyone been able to inject the NIC drivers for the DL150 to the WinPE boot disk? When I try to install the inf file, I get an error that says the inf file references a w2k sys file that cannot be found.
0 Kudos
1 REPLY 1
plem
New Member

‎09-19-2006 08:41 AM

‎09-19-2006 08:41 AM

Re: Cannot get ML150G2 to boot to network with WinPE

Go into the inf file, check which file it is referencing for windows 2000 and just change the somefileName.sys to the one you have for 2003. Do a replace all.

This will allow you to install the driver.

If this works, pls send me some points!

Cheers.
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.