- Community Home
- >
- Servers and Operating Systems
- >
- Legacy
- >
- ProLiant Deployment and Provisioning
- >
- Re: HPSS 8.30 + 2008 server + HP Servers
ProLiant Deployment and Provisioning
1753511
Members
4864
Online
108795
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-15-2009 01:22 PM
12-15-2009 01:22 PM
HPSS 8.30 + 2008 server + HP Servers
RDP 3.83, Altiris 6.9sp1 console.
I have a dl360g6 and a hp dl380g6, setup exact same image job to deploy to each of them (not at same time) the 360 will image with a rate of about 350mb min but the 380 will only image at like 10mb min, once i was done with the 360 i unplugged it and plugged in the 380 to use same 10/100 switch port. The switch is set to auto and the bios on both servers pxe nic1 is enabled. I have rebooted the network switch and the dhcp/pxe server as a troubleshooting step and no different, Any ideas or suggestions?
I have a dl360g6 and a hp dl380g6, setup exact same image job to deploy to each of them (not at same time) the 360 will image with a rate of about 350mb min but the 380 will only image at like 10mb min, once i was done with the 360 i unplugged it and plugged in the 380 to use same 10/100 switch port. The switch is set to auto and the bios on both servers pxe nic1 is enabled. I have rebooted the network switch and the dhcp/pxe server as a troubleshooting step and no different, Any ideas or suggestions?
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-21-2009 07:28 AM
12-21-2009 07:28 AM
Re: HPSS 8.30 + 2008 server + HP Servers
anybody? anybody?
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP