Proliant ML330 G3 Hypercfg does not work

[Mike Jones_17]

My ML330 G1 script does not work with the new CSB-6 ATA 100 IDE controller in the ML330 G3. I have tried to capture the array configuration using Hypercfg and no file is generated. Is there a new utility or workaround that anybody knows about?

[Jens Baumann_2 · Accepted solution]

HYPERCFG works - I just tried it out on one of our ML330 G3. Just boot using a DOS disk which you copied hypercfg onto, enter "HYPERCFG /L /F" and the configuration should be written into a file hypercfg.cfg

Is there any error message when you try to use it?

[Mike Jones_17]

Thanks, Hypercfg /L /F works. I was following the example in HP SmartStart Scripting Toolkit Best Practices: HYPERCFG /S /L /F A:\ML330G3.CFG and no file was generated.