ProLiant Deployment and Provisioning
cancel
Showing results for 
Search instead for 
Did you mean: 

Proliant ML330 G3 Hypercfg does not work

 
SOLVED
Go to solution
Mike Jones_17
Occasional Visitor

Proliant ML330 G3 Hypercfg does not work

My ML330 G1 script does not work with the new CSB-6 ATA 100 IDE controller in the ML330 G3. I have tried to capture the array configuration using Hypercfg and no file is generated. Is there a new utility or workaround that anybody knows about?
2 REPLIES 2
Highlighted
Jens Baumann_2
Frequent Advisor
Solution

Re: Proliant ML330 G3 Hypercfg does not work

HYPERCFG works - I just tried it out on one of our ML330 G3. Just boot using a DOS disk which you copied hypercfg onto, enter "HYPERCFG /L /F" and the configuration should be written into a file hypercfg.cfg

Is there any error message when you try to use it?

Mike Jones_17
Occasional Visitor

Re: Proliant ML330 G3 Hypercfg does not work

Thanks, Hypercfg /L /F works. I was following the example in HP SmartStart Scripting Toolkit Best Practices: HYPERCFG /S /L /F A:\ML330G3.CFG and no file was generated.