1467GB, SCSI, BD1468A4B5, Service Hours N/A

[llaehn]

Hello,

i have a ProLiant DL360G3 with two HP Harddrives. 1=BF1468B26B (HPB9) and 2=BD1468A4B5 (HPBC).
Drive 1 shows on the SMH no Service Hours, Secrors Read, Sectors Written and so on.
At Service Hours stands N/A and the table problem indicators and failure indicators ist not shown.
Smart Status is OK

I would see the data. whats wrong? What can i do?

Thanks for help
regards
lars

P.S. This thread has been moevd from Disk to ProLiant Servers (ML,DL,SL). - HP forum Moderator

[Víctor Cespón]

If you run an ADU report, that drive will probably appear with the message "drive is not stamped for monitoring" and all the drive statistics will be random numbers.
This is usually solved updating Smart Array and drive firmware.

[llaehn]

thanks for your reply,

i have firmware 2.76 on my controller and i reflashed the firmware for the drive. it doesnt helps.

i have tested some drives. BF1468B26B is a 15k drive. the BD1468A4B5 has 10k rpm. the 10k drive works fine. i tested the same with a hp 15k 73gb drive and the same problem occurs.

the adu report says the drive is not stamped.
but in the string of the hdd in the 10k drive stands vendor, firmware etc. in the 15k drive no vendor and firmware string but a long text about hp/compaq.

i think the 15k drive is not compatible with the dl360.

thanks for help
lars

[Víctor Cespón]

Probably not. BF1468B26B is a 347708-B22, and does not appear on the DL360 G3 quickspecs.

The BD1468A4B5 is a 286716-B22 and it's listed as compatible.

http://h18000.www1.hp.com/products/quickspecs/11504_div/11504_div.HTML