ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

207 memory initialization error on ml350 g6

 
thecyberman
Occasional Visitor

207 memory initialization error on ml350 g6

Hi i am trying to put 2 new sticks of 8Gb 240pin DDR3 PC3-10600 1333Mhz ECC Registered into a Proliant MK350 G6.  When i install a module in Slots A and B it picks up the Ram in Slot A and shows the server has 8Gb of Ram but then throws an error saying 207 error Memory Initialization Error.

 

I only have one processor in this server and according to the side panel the memory should go in alphabetically ie Slot A & B.

 

Any ideas?  What am i doing wrong?

 

Thanks

4 REPLIES
Murali_V
HPE Pro

Re: 207 memory initialization error on ml350 g6

Hi,

 

This could be faulty or incompatable DIMM / configuration issue.

 

Refer HP ProLiant ML350 Generation 6 (G6) QuickSpecs page 38 to 42.
http://www8.hp.com/h20195/v2/GetDocument.aspx?docname=c04286582

 

Refer the memory DDR3 memory population guidelines on Page 38

Swap the memory DIMMs and check if error follows the DIMMs

 

Also, let us know what is the part number of the DIMMs installed.

 

Regards,

Murali Mohan

Was this post useful? - You may click the KUDOS! thumb below to say thank you...
Murali_V
HPE Pro

Re: 207 memory initialization error on ml350 g6

Also, refer the following HP ProLiant ML350 G6 Server - Spare Partspage and ensure that the DIMM part numbers are supported.
http://h20564.www2.hp.com/hpsc/doc/public/display?docId=emr_na-c01725643

Was this post useful? - You may click the KUDOS! thumb below to say thank you...
thecyberman
Occasional Visitor

Re: 207 memory initialization error on ml350 g6

Thanks 

 

I checked the guide you sent the link for.  On page 39 its says install in Slot A then B which i have done so i think the confiiguration is right. 

 

 

Murali_V
HPE Pro

Re: 207 memory initialization error on ml350 g6

Ok, you may try swapping the DIMMs to check if the error follows the DIMM. Error indicates that issues is with DIMM installed in Slot A.

You may also run Insight diagnostics to confirm the Faulty DIMM.

Was this post useful? - You may click the KUDOS! thumb below to say thank you...