540-BMC SDR version error (Proliant ml150 g5 )

[ssg099]

Hello to everyone.
I have faced a problem on my hp server.
I don't know why but once then I rebooted it, server has strated a long time and coolers've run very loudly. There is some errors:
Flashing BMC SDR/config...... Please wait
Do not power cycle or reset the system, may takes several minutes....error

603-note please upgrade LightsOut 100 BMC fw 3.10 or higher
540-BMC SDR version error
The server doesnt have additional LO card
Server PN: 460094_001

[ssg099]

I've installed SP51259 by ROMpac utility, but issue still presents.
SP49103 is not compatible with my server because an additional card LO is absent I suppose.
Could you help me please?

[ssg099]

Hello

I have found some topics with similar problems but everywhere Lo card presents. 

In my case there is no any card for remote management and if I try to update BMC firmware I have an error that chipset Intel is not found (or something like this). 

I dont now why this problem appeared and I really need for your help.

There is a screenshot with errors:

[SanjeevGoyal]

Hello,

This seems to be the firmware update process did not complete successfully

Steps :
Power Cycle the Server (shutdown the server and remove all the cables including network and ILO)

Update the system bios using Rompaq

Update the LO100 firmware using TFTF alternatively as this takes less than 10 seconds to update the firmware.

If you feel this was helpful please click the KUDOS! thumb below!   

Regards,

[ssg099]

Hello.

 SanjeevGoyal thank you very much for you answer.

IF I catch it correctly firstly I should update BIOS using this ROMpaq SP51259.exe  and after that I update LO100 using SP49103.exe ? But what daes it mean TFTF? May be do you have any instructions for this process please?   And I dont have any LO cards (I've writen it above). What firmware should I use?

Thank you.

[SanjeevGoyal]

Hello,

I would suggest you have a proper case be logged with HPE, and share the appropriate logs for further analysis.

Regards,

[ssg099]

Hello

This Saturday I tried to update firmare once again.

51259 was updatet without problem. But during updating 49103 I had an error: "Intel chopset not supported" 

@SanjeevGoyal thanks fow your advice to logged may case with HPE. Could you consult me how I can do it. We bought the  server long time ago (2009), I am not sure than our warranty is stil active.