6 Fan jumper for Fan-board 442955-001

[Ghosteo]

While troubleshooting a fan issue between my 2 DL380 G% servers I lost the plastic jumper that enables the 6 fan configuration.  I now get an insufficient cooling error that prevents my boot up.  I have not been able to secure just the jumper anywhere. Can anyone help me get one, or at least tell me what pins were jumped with that jumper?

Thanks

[PZel]

That would be a straight connection between pin 1 and 4 on J7 (FAN6). That's all.

[Ghosteo]

Thanks for responding. The PCB doesn't show which pin is #4, just 1,2,5,and 6.  I think it is under pin 1 (because there is what looks like the number 4 stamped on the black plastic connector) but am not sure. Does anyone know which is pin #4?

Thanks

[PZel · Accepted solution]

When you look at the soldering side (back) of the printboard, its layout is: (FAN6)

<VIDEO CONNECTOR>

2   1

4   3

6   5

<CONNECTIONS TO MOTHERBRD>

[Ghosteo]

BRAVO PZ!

Right on the money with the Jumper coonection as well as the pin identification.  Thank you. I am back up!