ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

A problem with iLO on HP ProLiant ML370 G3

lectrouser
Occasional Advisor

A problem with iLO on HP ProLiant ML370 G3

Hello all!

I have received an ML370 G3 server to maintain and to test it.

It has an iLO port on the rear panel of it. But there is no any iLO related message during boot process, so I can't configure it. System management homepage also says that there is no any management processor in system.

 

Thanks for help.

2 REPLIES
shooreg
Frequent Advisor

Re: A problem with iLO on HP ProLiant ML370 G3

Looks like your iLO has been secured by previous admin, so you need to reset it

 

For the ML370 G3 it is the system maintenance switch "SW1". Remove power from server and swich it to the ON state - then apply power back and poweron your system -  the iLO configuration should be cleared.

 

Be aware - you can loose your advanced licences (if any) stored in iLO's NVRAM as well as its IP config and passwords.

 

 

Murali_V
HPE Pro

Re: A problem with iLO on HP ProLiant ML370 G3

 Yes, resetting ilo should resolve this issue, refer the following document for more information:

http://h20000.www2.hp.com/bizsupport/TechSupport/Document.jsp?lang=en&cc=us&objectID=c02996384&prodTypeId=18964&prodSeriesId=397989

 

Regards,

Murali Mohna

Was this post useful? - You may click the KUDOS! thumb below to say thank you...