cancel
Showing results for 
Search instead for 
Did you mean: 

BL25

Asif Hirji
Occasional Visitor

BL25

Has anyone resolved the issue with a BL25 Blade Server not booting up. Have 2 enclosures full of BL20's and 1 BL25. The BL25 is in an enhanced enclosure, firmware upgraded to 2.30. Sufficient power to power the enclosures and blades. HP tried to resolve the issue and thought they did. Installed back at a customer site, worked for 1 reboot and failed again. According to HP, the blade had bad memory and all 4 pieces were replaced. Console on the ILO say unsupported text mode. I have replaced the power module, power regulator, system board and now all the memory. each processor has 2 x 512MB. Advised by HP that there was a service advisory out on the BL25 but cannot locate it. Does anyone have a situation on this nature and if so, was there a resolution! is anyone also aware of this service advisory, can anyone supply this advisory to me. Thanks.