BL40 ILO

i have Proliant BL40 server ,i can connect to the server by using Rear ILO port without any problem ,but when i try to connect to Front ILO port via Normal network cable using my note book (or any PC) i note that the netowrk interface always unplugged.
i try to connect this notebook with the same cable to another Blase server and it is work.
the firmware got ILO is updated.

9 REPLIES 9

Do you connect to the bl40 using the same dongle for the front ilo connection as the failed one..?

Nothing is impossible for those that don't have to do it themselves!

yes i connect by using the same one.
now i try to use other pc .
it connected but when i PING the ILO ip it get Request Time out and also it reply from another Blasdes!!!

IP: 192.168.1.1 ?

Nothing is impossible for those that don't have to do it themselves!

My PC IP is 192.168.1.2/24
the server IP 192.168.1.1/24

Call HP support and request part replacement.

Maybe: I/O, Video, and USB pass-thru board 360289-001

Let the guys check first....

Nothing is impossible for those that don't have to do it themselves!

i already Did that , i exchanged this part and its cable with another server.
but i still have the same problem with the new part

:-) replace part on the ethernet path...there is nothing else to say. If it works on other servers of the same type...there is nothing else to do....

Nothing is impossible for those that don't have to do it themselves!

Thanks for your advices ,may i need to change the Main board.

It's possible, but since it's working from the back, i presume the logic is ok...maybe just connections...

Nothing is impossible for those that don't have to do it themselves!