HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
cancel
Showing results for 
Search instead for 
Did you mean: 

BL40 ILO

 
DP with exchange cluste
Occasional Advisor

BL40 ILO

i have Proliant BL40 server ,i can connect to the server by using Rear ILO port without any problem ,but when i try to connect to Front ILO port via Normal network cable using my note book (or any PC) i note that the netowrk interface always unplugged.
i try to connect this notebook with the same cable to another Blase server and it is work.
the firmware got ILO is updated.
9 REPLIES
Bostjan Kosi
Trusted Contributor

Re: BL40 ILO

Do you connect to the bl40 using the same dongle for the front ilo connection as the failed one..?
Nothing is impossible for those that don't have to do it themselves!
DP with exchange cluste
Occasional Advisor

Re: BL40 ILO

yes i connect by using the same one.
now i try to use other pc .
it connected but when i PING the ILO ip it get Request Time out and also it reply from another Blasdes!!!
Bostjan Kosi
Trusted Contributor

Re: BL40 ILO

IP: 192.168.1.1 ?
Nothing is impossible for those that don't have to do it themselves!
DP with exchange cluste
Occasional Advisor

Re: BL40 ILO

My PC IP is 192.168.1.2/24
the server IP 192.168.1.1/24
Bostjan Kosi
Trusted Contributor

Re: BL40 ILO

Call HP support and request part replacement.

Maybe: I/O, Video, and USB pass-thru board 360289-001

Let the guys check first....
Nothing is impossible for those that don't have to do it themselves!
DP with exchange cluste
Occasional Advisor

Re: BL40 ILO

i already Did that , i exchanged this part and its cable with another server.
but i still have the same problem with the new part
Bostjan Kosi
Trusted Contributor

Re: BL40 ILO

:-) replace part on the ethernet path...there is nothing else to say. If it works on other servers of the same type...there is nothing else to do....
Nothing is impossible for those that don't have to do it themselves!
DP with exchange cluste
Occasional Advisor

Re: BL40 ILO

Thanks for your advices ,may i need to change the Main board.
Bostjan Kosi
Trusted Contributor

Re: BL40 ILO

It's possible, but since it's working from the back, i presume the logic is ok...maybe just connections...
Nothing is impossible for those that don't have to do it themselves!