- Community Home
- >
- Servers and Operating Systems
- >
- ProLiant
- >
- ProLiant Servers (ML,DL,SL)
- >
- Backup problem...
ProLiant Servers (ML,DL,SL)
turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
-
- Categories
- Blogs
-
Quick Links
- Community
- Getting Started
- FAQ
- Ranking Overview
- Rules of Participation
- Contact
- Email us
- Tell us what you think
- Information Libraries
- Integrated Systems
- Networking
- Servers
- Storage
- Other HPE Sites
- Support Center
- Enterprise.nxt
- Marketplace
- Aruba Airheads Community
-
Forums
-
Blogs
-
InformationEnglish
Backup problem...
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
07-21-2002 04:00 PM
07-21-2002 04:00 PM
Backup problem...
Backup problem...
Hi,
I have a problem with my backup. In the event viewer I got a lot of "The device, \Device\Tape0, has a bad block" errors. I thought it was hardware related so I bought a new drive. The old drive was a HP 24i connected on the SCSI interface and the new one is a Compaq AIT 35 connected on the IDE-bus. Now to the problem, I still got the error!! The description is as above and the Event ID: 7, Source: caitn4i.
Sometimes, in most cases after a cold boot, the backup (NTBACKUP) is working ok!
I have the latest SPs, SP6 for NT and SP4 for Exchange, I also have checked the BIOS and it is the latest?
Any ideas?
Jan
I have a problem with my backup. In the event viewer I got a lot of "The device, \Device\Tape0, has a bad block" errors. I thought it was hardware related so I bought a new drive. The old drive was a HP 24i connected on the SCSI interface and the new one is a Compaq AIT 35 connected on the IDE-bus. Now to the problem, I still got the error!! The description is as above and the Event ID: 7, Source: caitn4i.
Sometimes, in most cases after a cold boot, the backup (NTBACKUP) is working ok!
I have the latest SPs, SP6 for NT and SP4 for Exchange, I also have checked the BIOS and it is the latest?
Any ideas?
Jan
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
End of content
United States
Hewlett Packard Enterprise International
Communities
- Communities
- HPE Blogs and Forum
© Copyright 2018 Hewlett Packard Enterprise Development LP