Boot from SAN, Blade 30p, EVA 4000.

[Jorge_43]

Hi everyone, I need help about boot from SAN. I have one EVA4000 and 1 Blade30p. I folowing all step the guide configuration boot SAN, but it fail. I upgraded firmware HBA FCA2214, XCS 5110, CV 5.03 and the zone into the Sanswitch is single path.

Once tha the instalation scrip of the RDP 3.0 is run, it failed whith the folowing error. (see attachment).

If someone know something.....

Thanks

[David_450]

the error you are getting is because of Zoning issue. you need to have only one path on the first HBA only.
the HBA needs to be enalbed too.
after the install and install of MPIO you can add back the second HBA and zone it all back.


Good luck