HPE Community
ProLiant Servers (ML,DL,SL)
1752805 Members
5669 Online
108789 Solutions
New Discussion

Re: Boot problem

 
Ayman Altounji
Valued Contributor

‎05-30-2001 04:00 PM

‎05-30-2001 04:00 PM

Boot problem

I just installed two more processors into my ProLiant 6500 running Windows 2000, both processors were recognized in BOOS. I then went into System configuration and confirmed that PIC Mode had "Full Table, Mapped" selected. Then I went into Windows system configuration and selected "APCI Multiprocessor". After that I re booted the system and now it will not boot past the "Starting Windows" screen. I've tried starting "Last Known Good" and "Safe Mode", but windows stalls at the same spot. Any help would be great. Thanks
0 Kudos
Reply
1 REPLY 1
Ayman Altounji
Valued Contributor

‎05-30-2001 04:00 PM

‎05-30-2001 04:00 PM

Re: Boot problem

Never mind, I did a Windows repair and got they system working again. Thanks Anyways.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.