ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

CGESM will not power up

James Williamson_1
Occasional Visitor

CGESM will not power up

Has anyone had a problem that a CGESM will not power up after it is inserted? We have an enclosure that needed one of the switches replace. The switch will power up in other enclosures and other switches will power up in the same slot. Any ideas?
3 REPLIES
raadek
Honored Contributor

Re: CGESM will not power up

I would check whether the firmware level on the enclosure is not outdated.

Other than that - no ideas.
Don't panic! [THGTTG]
James Williamson_1
Occasional Visitor

Re: CGESM will not power up

Yes we have updated the firmware on all management modules and power enclosures and I have reset all the management modules and the power enclosures as well.
Oleg Koroz
Honored Contributor

Re: CGESM will not power up

pull GB and CUBE out try once again, also pull MM and try without it if CGESM will go on, same problem at A or B side - replace it