ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

CL 380 CR3500 utility cannot identify drives

 
pat_86
Occasional Contributor

CL 380 CR3500 utility cannot identify drives

I configured 2 nodes of CL 380 with networking on win2k advanced for a test cluster set up. All times CR3500 was shut down. When i fire node 1 and then try configuring the CR3500 utility it comes up with an error - cannot find drives.

When i go to the boot sequence i do not see the CR 3500 coming up any where in the boot sequence. However when i see the system info using F10 --> inspect data ---then i see 2 CR3500 entries each connected to Slot 2 (Port1).
2 REPLIES
pat_86
Occasional Contributor

Re: CL 380 CR3500 utility cannot identify drives

Additional info

I use embedded compaq array controller(its controller order is first) for all my local OS + data.

Compaq 64 bit dual channel Slot 2 (Port1)
SCSI Resources - Enabled
Controller order - Third
Host adapter - 1
SCSI ID #7
Attached devices
SCSI ID 2 Compaq CR3500 Reserved Devices
SCSI ID 3 Compaq CR3500 Reserved Devices

Compaq 64 bit dual channel Slot 2 (Port2)
SCSI Resources - Enabled
Controller order - Fourth
Host adapter - 2
SCSI ID #7





pat_86
Occasional Contributor

Re: CL 380 CR3500 utility cannot identify drives

Hi

I played with the diagnostic utilities and a restart now is able to get me to see the all the shared drives through the CR3500 utility. Wonder how can a diagnostic run resolve the issue.