HPE Community
ProLiant Servers (ML,DL,SL)
1752762 Members
5097 Online
108789 Solutions
New Discussion юеВ

Can't detect 4mm 12/24Gb DAT tape drive

 
Ayman Altounji
Valued Contributor

тАО06-24-2001 04:00 PM

тАО06-24-2001 04:00 PM

Can't detect 4mm 12/24Gb DAT tape drive

Although the DAT drive is detected by SCSI on boot-up, when I try to configure the drive, Windows says it can't find it!
0 Kudos
Reply
2 REPLIES 2
Mark Cloutier
Respected Contributor

тАО11-26-2001 04:00 PM

тАО11-26-2001 04:00 PM

Re: Can't detect 4mm 12/24Gb DAT tape drive

are you trying to get NT to detect it or are you using the compaq scsi drivers for it?
We are here for a good time, not a long time!
0 Kudos
Reply
Ayman Altounji
Valued Contributor

тАО02-12-2002 04:00 PM

тАО02-12-2002 04:00 PM

Re: Can't detect 4mm 12/24Gb DAT tape drive

Hi

I'm having the same thing here , we switched from a proliant 2500 to a proliant ML350 .
The System does not recognize the DAT ( a Compaq SDT 9000 ) , no matter what drivers we use ( Compaq , sony , Veritas , Microsoft ) .
In fact we can't assign the driver to the device because NT does not locate any tape device .
What is the meaning of the jumpers on the back of the device ?
How should we install it ( what channel should we put it ? )

thx
Dries
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.