HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

Compaq Proliant ML370 Server Raid Issues

 
Timothy J. Ward
Occasional Contributor

Compaq Proliant ML370 Server Raid Issues

Have a red light on one of the drives, what is the management software that I can run on Netware 5.0..

Has been quite some time since we have had to run it and I can't remember what I have to run.
2 REPLIES
Scott Robey
Frequent Advisor

Re: Compaq Proliant ML370 Server Raid Issues

You need to run the SNMP management agents. If already installed, use a browser to poing to the IP address of the server port 2301 (http://:2301)
If the agents are not installed then You would need to install the latest agents/PSP for netware 5.x found here --> http://h18023.www1.hp.com/support/files/server/us/locate/32_1119.html#0

The RAID device driver should have also posted a message on the server console indicating what the problem was, more than likely you have a failed drive and if the server is under warranty you can call into support and get it replaced.

Thanks and I hope this helps.
Timothy J. Ward
Occasional Contributor

Re: Compaq Proliant ML370 Server Raid Issues

Is there anything that can be run at the server?

I did what you said, but I didn't install it, so I don't know what the username/password is for it.

I guess a re-install would fix that, but I would rather just run something from the system console if I could...