HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

Confirming that the DL580 “node memory interleaving” is disabled

 
ironmantom
Occasional Contributor

Confirming that the DL580 “node memory interleaving” is disabled

Where in the BIOS after post can you confirm “node memory interleaving” is disabled? Is this already done by default in a brand new system out of the box?

 

1 REPLY
Suman_1978
HPE Pro

Re: Confirming that the DL580 “node memory interleaving” is disabled

Hi,

 

As far as I know these options are for AMD rather than Intel based servers.

 

Under RBSU:

 

Power Management Options > Advanced Power Management Options > Memory Interleaving
This feature modifies the level of interleaving for the memory system configuration. Typically, higher levels of memory interleaving result in maximum performance. However, reducing the level of interleaving can result in power savings.

My understanding is Memory Interleaving is Full Interleaving by default.


Advanced Options > Node Interleaving

Node Interleaving disables the NUMA architecture properties of the system. All operating systems supported by this platform support NUMA architectures. In most cases, you can obtain optimum performance by disabling Node Interleaving. When this option is enabled, memory addresses are interleaved across the memory installed for each processor. When this option is enabled, some workloads may see improved performance.

My understanding is Node Interleaving is Disabled by default.

 

Hope this helps.