ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

Control fan speed on HP ProLiant ML10 Gen9

 
ChrisVH
Advisor

Control fan speed on HP ProLiant ML10 Gen9

Hello,

My HP ProLiant ML10 Gen9 is working just fine but the noisy fan is a bit annoying. I installed SpeedFan like I did on my previous server but running SpeedFan causes my server to crash. Fan speed changes to low, then to high, followed by a reboot.

Any ideas how to get SpeedFan to work or to lower fan speed? I have a PWM controller but I wonder whether there's any better way?

2 REPLIES
sgiordy
Occasional Advisor

Re: Control fan speed on HP ProLiant ML10 Gen9

Hi Chris,

seems that G9 has issues with fan control... check my post for possible similarity... maybe a common solution will exists

https://community.hpe.com/t5/ProLiant-Servers-ML-DL-SL/DL120-G9-Noise-due-fans-stuck-at-40/td-p/6968218

S.

Re: Control fan speed on HP ProLiant ML10 Gen9

Hi @ChrisVH

Reseat the ambient sensor cable for problem fix and latest bios update.

if problem persist, replace this parts 42937-001 - Fan module 92x92x25mm - For use with ML10 Gen9 /  842940-001 - SPS-Heatsink ML10 Gen9

Kind Regards,
Erdogan.
I am HPE Employee

If this helps you with your issue, please click the thumb to register a Kudo.
If it resolves the issue, please consider marking it as an Accepted Solution.
The comments in this post are my own and do not represent an official reply from the company. No warranty or guarantees of any kind are expressed in my reply.