Community
ProLiant Servers (ML,DL,SL)
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

DL 360 GEN8 CTRL+S stopped working after latest SPP

 
chic_cat
Occasional Visitor

‎05-09-2018 11:46 AM - edited ‎05-09-2018 11:46 AM

‎05-09-2018 11:46 AM - edited ‎05-09-2018 11:46 AM

DL 360 GEN8 CTRL+S stopped working after latest SPP

Hello,

I recently upgraded our 3 dl360 gen8 to the latest spp.

CTRL+S stopped working (I used to configure pxe vlan in there)

Now it just shows this screen (Attachement)

`No Active Broadcom Devices Found!

Press any key to Continue`

Is there any workaround?

PS. All interfaces are enabled for network book in the Bios.

 

Thank you

0 Kudos
Reply
1 REPLY 1
shakir_saifi
Advisor

‎06-06-2018 03:43 AM

‎06-06-2018 03:43 AM

Re: DL 360 GEN8 CTRL+S stopped working after latest SPP

Kindly confirm from which SPP version you have used to update the firmware for further investigation?

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.