HPE Community
ProLiant Servers (ML,DL,SL)
1753454 Members
6380 Online
108794 Solutions
New Discussion

Re: DL 380G6 - Slow boot – initializing P411

 
KaneK
Occasional Advisor

‎07-30-2010 08:20 AM

‎07-30-2010 08:20 AM

DL 380G6 - Slow boot – initializing P411

We just installed a new P411 SAS card with a BBWC module. The server boots slowly while initialing the P411. Server 2008 R2 (Device Manager) reports that the P411 "cannot start." Any Suggestions?
0 Kudos
Reply
2 REPLIES 2
KaneK
Occasional Advisor

‎07-30-2010 10:10 AM

‎07-30-2010 10:10 AM

Re: DL 380G6 - Slow boot – initializing P411

Just took the BBWC and the RAM module out and the server booted quickly. Going to try and boot with just the RAM module.
0 Kudos
Reply
KaneK
Occasional Advisor

‎07-30-2010 11:34 AM

‎07-30-2010 11:34 AM

Re: DL 380G6 - Slow boot – initializing P411

Added the RAM module back in. We were then able to enter the ROM configuration during system boot. Leaving the BBWC module out until it is configured then we will try and add it again.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.