DL140 G3

[Frank Ciarniello]

Is there a problem with the mouse port when using a Server Console Switch (2 x 16 port)?

The mouse does not work on any DL140 servers

[KarloChacon]

hi

I've seen this issue a lot of times here at forums

What I read some time ago what that ilo firmware 2.12 was buggy so some people got it working fine using 2.11 or 2.10

that seeing your issue
I want to ask you:
do you know servers firmware for lo100?

at that time when I read that there was not 2.13 firmware version now it is available

check this link so you can test different lo100 version

2.13 or 2.11

http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareDescription.jsp?lang=en&cc=us&prodTypeId=15351&prodSeriesId=1842838&swItem=MTX-78ed49fe647a47f6bc33683862&prodNameId=3285485&swEnvOID=1005&swLang=8&taskId=135&mode=5


thread
http://forums12.itrc.hp.com/service/forums/questionanswer.do?admit=109447627+1207284359397+28353475&threadId=1107561


try and let us know

regards

[YAQUB_1]

Hi Frank,

Can U change or unplag & plug Ur mouse & keyboard cable.

Check & confirm me....

Thanks--Yaqub
HP Support!!!

[Frank Ciarniello]

The firmware was 2.13, I have downgraded to 2.10 and after unlugging and reconnecting the keyboard and mouse cables, the system worked.

Then after a reboot the mouse will not work again even after resetting the cables.

I am going to try a cold boot to see if that helps.