Community
ProLiant Servers (ML,DL,SL)

DL20 Gen10 with embedded S100i controller does not boot after install CentOS

 
Ashwin-Scindhe
Advisor

‎11-11-2019 06:32 PM

‎11-11-2019 06:32 PM

DL20 Gen10 with embedded S100i controller does not boot after install CentOS

DL20 Gen10 with embedded S100i controller does not boot after install CentOS.

The insatallaion is succesful bute does not boot.

Unable to find drivers to install using modprobe

Tried Software RAID on the OS still cannot boot

0 Kudos
Reply
2 REPLIES 2
Sebasbin
HPE Pro

‎11-12-2019 02:41 AM

‎11-12-2019 02:41 AM

Re: DL20 Gen10 with embedded S100i controller does not boot after install CentOS

Hello Ashwin,

HPE Array S100i SR Gen10 SW RAID is only supported on Windows.

Please find the below Quick specs

https://h20195.www2.hpe.com/v2/getdocument.aspx?docname=a00019427enw


Note: While I am an HPE Employee, all of my comments (whether noted or not), are my own and are not any official representation of the company

Accept or Kudo

0 Kudos
Reply
Jimmy Vance
HPE Pro

‎11-12-2019 05:12 AM

‎11-12-2019 05:12 AM

Re: DL20 Gen10 with embedded S100i controller does not boot after install CentOS

@Ashwin-Scindhe wrote:

DL20 Gen10 with embedded S100i controller does not boot after install CentOS.

The insatallaion is succesful bute does not boot.

Unable to find drivers to install using modprobe

Tried Software RAID on the OS still cannot boot

Refer to my comments in the other thread you have posted in

No support by private messages. Please ask the forum! 
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.