ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

DL320 didnt boot from CD or Disk for first installation

SOLVED
Go to solution
Pieczynski
Occasional Visitor

DL320 didnt boot from CD or Disk for first installation

Hallo,

i tried to install w2k server on the DL320 but the system didnt read from CD or floppy drive.
System comes up with memory test and than it shows the build in processor
-------Screen----------------------------
128MB
Processor Pentium (R) III with 1,26 ghz...
---------------------------------------
but than it stops.
The pressing of F9 key has also no effekt.

I used different BootCds but always no effekt.

any Idea what it can be?
thanks & regards
Thomas
2 REPLIES
Sunil Jerath
Honored Contributor
Solution

Re: DL320 didnt boot from CD or Disk for first installation

Hello Thomas,
Please make sure that everything is sitting in properly in the server. If not then it could be a system board problem. Also make sure that there is no third party hardware in the system. Actually if you have the server attached to a KVM then remove it. Once the installation finishes then attach it back.

Regards,
Pieczynski
Occasional Visitor

Re: DL320 didnt boot from CD or Disk for first installation

Thnx for help,

the problem was the KWM.


regards
Thomas