- Community Home
- >
- Servers and Operating Systems
- >
- HPE ProLiant
- >
- ProLiant Servers (ML,DL,SL)
- >
- Re: DL360 G3 remove SYSLINUX from boot
ProLiant Servers (ML,DL,SL)
1753797
Members
7400
Online
108799
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-21-2007 10:47 PM
06-21-2007 10:47 PM
DL360 G3 remove SYSLINUX from boot
Hi
I have inhertited a HP DL360 G3 server that was running Linux (Fedora Core 6). I wish the server to run Windows Server 2003. It has 2 drives (72gig) running as raid 1+0. HP smartstart is being used to load and configure the server package.
After server installation has finished and the server reboots, the following appears on screen:
SYSLINUX 1.75 (date) Boot Failed.
I guess this means that the Linux loader is still in the mbr of the disk array.
Any ideas on how I would clear the mbr so that I can get Windows to install and run?
Thanks
I have inhertited a HP DL360 G3 server that was running Linux (Fedora Core 6). I wish the server to run Windows Server 2003. It has 2 drives (72gig) running as raid 1+0. HP smartstart is being used to load and configure the server package.
After server installation has finished and the server reboots, the following appears on screen:
SYSLINUX 1.75 (date) Boot Failed.
I guess this means that the Linux loader is still in the mbr of the disk array.
Any ideas on how I would clear the mbr so that I can get Windows to install and run?
Thanks
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-22-2007 12:29 AM
06-22-2007 12:29 AM
Re: DL360 G3 remove SYSLINUX from boot
There was a linux boot sidk in the floppy drive - i lol so much when i found it
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP