HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

DL360 G4p system diagnostic LEDs

 
Monsoft
Occasional Contributor

DL360 G4p system diagnostic LEDs

Hi,

My server just died :(
I was working on it and in the moment one harddrive went down, and whole server start being unacceptable. I rebooted server and still nothing, even iLO stop responding.

I noticed that there is some system diagnostic leds on motherboard (module of 9 leds) but I couldn't find any documentation what they mean.

Is anyone could point me to some document or website where I can find some information bout these leds ?
5 REPLIES
juan quesada
Respected Contributor

Re: DL360 G4p system diagnostic LEDs

the P stands for performance, but in the end is a dl360 g4...
http://bizsupport1.austin.hp.com/bc/docs/support/SupportManual/c00218204/c00218204.pdf
Monsoft
Occasional Contributor

Re: DL360 G4p system diagnostic LEDs

Unfortunately I saw this document before and there is nothing about this leds except information that on page 70:
"System diagnostic Refer to the HP Remote Lights-Out Edition II
User Guide" but even in this document there is nothing about them :(
juan quesada
Respected Contributor

Re: DL360 G4p system diagnostic LEDs

i guess that you are looking at the port 84/85 binary LED code.... thats HP internal, they do not share the meaning for each of those lights...

for your situation i recommend to minimize the system, 1 processor, memory, no cd/dvd , no PCI.. etc...swap components as needed.

try also going to back up bios by setting switch 1,5 6 to on and booting up.

regards,
Monsoft
Occasional Contributor

Re: DL360 G4p system diagnostic LEDs

Thanks for tips.

I already striped off server and ran it on minimal configuration. And still nothing.

I setup switched 1,5 and 6 to ON and boot server but nothings happened. All diagnostic leds went off but server started beeping and nothing was on the screen.
Unfortunately I don't have another server to swap components :(

Looks like I have to buy another machine :(
Monsoft
Occasional Contributor

Re: DL360 G4p system diagnostic LEDs

This is how it's look on my server.

After boot leds CR16,CR17 and CR23 remains.